Technical screening-media supportannie.lu@huataogroup.comDownloadsProject list 0Ask a question
HUATAO Screening Media

Buying guides

How to measure a replacement screen panel

A measurement guide for replacement-screen identification.

Measure the overall length, width and thickness and mark the feed direction. Record aperture width and length separately and identify whether the opening is square, rectangular, slotted or another shape.

Photograph hooks, rails, tongues, sealing strips, curved surfaces and support contact points. Include an existing drawing or part label when available.

Do not assume two panels with the same overall dimensions are interchangeable. Fixing geometry, curvature, tolerance, material and operating duty also affect fit and performance.

Frequently asked questions

Which dimensions should be captured for a replacement panel?

Record the overall envelope and thickness, aperture dimensions and shape, panel profile, fixing or retaining features, support contacts and sealing interfaces. Use consistent units and identify the measurement datum and feed direction.

Should the panel be measured at only one point?

Use the same datum and direction for repeat measurements, and check relevant edges and interfaces for variation, wear or deformation. Compare the readings with the controlled drawing rather than relying on one nominal measurement.

Which photographs help a technical review?

Provide labelled views of the top and underside, fixing and sealing edges, support contact, installed deck and any part marking. Include a scale or recorded dimensions, and identify feed direction and drawing revision if known.

Discuss the application with HUATAO

Share the complete model or drawing revision, screen and deck interface, material, duty and target outcome so the technical review can identify open items.

Send project requirements